Brake, Clutch, Differential, Rear Axle & Transmission
ACS070 Riveted Brake Shoes (Pair)- Fits: D10, D12, D14, D15 (up to sn 9001), G, 1 Pair is for 1 wheel only1 3/4" Wide
|
ACS251 Brake Shoe Lining Set - Fits: D10, D12, D14, D15 (up to sn 9001), G, 1 set is for 1 wheel only1-3/4" wide8-1/8" length0.190" thick
|
MIS1131 Brake Riveting Tool - 1-1/4" throat depth1/8" diameter rivet punch5/16" anvil
|
MIS2547 Deep Throat Brake Rivet Tool - 3-3/8" Deep Throat2-1/8" high throat - USA Made
|
ACS300 Brake Rod Return Spring - 9-9/16" overall length
|
ACS298 Brake Shoe Spring - 2-3/16" overall length - USA Made
|
ACS007 Brake Drum - are made from ductile iron which is far superior to cast iron brake drums
|
ACS2545 Brake Pedal Shaft and Bushings
|
MFS1351 Seal - 1.750" I.D., 2.690" O.D., .315" Wide
|
ABC1628 Differential Carrier Seal - Fits Allis D10, D12, D15 and G as an inner axle seal
|
ACS1314 Rear Axle Bearing - 1.5748" ID --- 2.6772" OD --- 0.591" Width
|
ABC550 New Pressure Plate - 6-1/2" diameter
|
MHS076 Clutch Disc 6 1/2 Inch 10 Spline - 6-1/2" diameter, 15/16" x 10 tooth spline
|
ACS076 Throw Out Bearing - Center hole = 1.500"
|
IHS730 Clutch Pilot Bushing - Sintered bronze. 0.815" Outside Diameter, 0.625" Inside diameter, 1.000" Length.
|
ABC1437 Clutch Alignment Tool - Plastic, 10 Splines, 15/16" Spline O.D.,0.625 Pilot Diameter
|
ACS263 Rubber Gear Shift Boot
|
ACS254 Gear Shift Lever Washer And Snap Ring Kit - Retains gear shift lever into housing, 0.254" Thick, 1.368" O.D., 0.998" I.D.
|
ACS253 Oversized Gear Shift Lever Pins
|
ACS255 Standard Gear Shift Lever Pins - 0.314" width for the square end 0.250" shaft diameter
|
ACS006 Rear Axle - 24-3/8" overall length
|
|
|