Brake, Clutch, Differential, Rear Axle & Transmission
IHS2996 Clutch Kit - 10-1/2" O.D. 1.125" Clutch spline I.D. 1.687" Pressure plate spline I.D. 16 pressure plate splines
|
IHS2993 New Pressure Plate - 10-1/2" O.D. 16 splines 1.687" spline I.D. 1.188" flywheel step
|
IHS2990 New Woven Clutch Disc - 10-1/2" O.D. 10 spline 1-1/8" spline I.D.
|
ABC496 Clutch Throw Out Bearing (IH Torque Amplifier Release Bearing) - 2.062" I.D. 0.801" thick 3.269" face diameter (this is where the pressure plate fingers make contact)
|
ABC2988 Throw-out Bearing Clutch - 2.375" I.D., 3.500" O.D., 0.730" wide
|
ABC2992 Pilot Bearing - Sealed, 0.787" I.D., 2.047" O.D., 0.590" wide
|
ABC3000 Clutch Pilot Bearing - Sealed, 0.787" I.D., 1.850" O.D., 0.551" wide
|
|
ABC3109 Clutch Alignment Tool - Fits 300, 330, 340, 350, 460, 504, 544, 606, 656, 664, 666, 686, 2504, 2544, 2606, 2656, 3514, 3616
|
IHS873 Clutch Pedal Return Spring - 0.073" wire diameter, 3.850" overall length, 0.620" body diameter.
|
IHS266 Gear Shift Knob - Can also be used as a reverser knob. 0.375" Hole dia.
|
IHS780 Position Control Handle Knob - 3/8 - 24 fine thread --- Hole diameter: 3/8 NF --- Width: 1.062" --- Height: 0.940"
|
IHS2480 Rubber Gear Shift Boot - 4-3/4" tall
|
IHS3314 Premium Shift Lever Repair Pin Kit - USA Made
|
IHS981 Shift Lever Repair Pin Kit
|
IHS1307 Trans Drive Shaft / Input Shaft Oil Seal - 1.875" I.D., 2.627" O.D., 0.312" wide
|
ABC1501 Forward and Reverse Clutch/Transmission Oil Seal - 1.125" I.D., 1.565" O.D., 0.250"
|
IHS3081 Torque Amplifier Clutch Control Rod Pin - 2.125" overall length, 0.497" O.D. end and 0.558" O.D. shoulder
|
IHS3071 Torque Amplifier Operating Handle Stop Pin - USA Made
|
IHS3078 Torque Amplifier Operating Handle Pivot Bolt - made for a worn handle hole, 7/8" oversize shoulder diameter (must drill handle for oversize bolt)
|
IHS3075 Torque Amplifier Operating Handle Pivot Bolt
|
IHS3902 Torque Amplifier Operating Handle Pawl Grip Pin - 0.243" O.D., 0.375" O.D. head, 0.853" overall length - USA Made
|
IHS1888 Torque Amplifier Handle Spring - - 3.0" Overall length, .104 O.D.
| |
|
|