Brake, Clutch, Differential, Rear Axle & Transmission
JDS5948 Brake Plate Spring USA MADE
|
JDS888 Clutch Pedal Return Spring - USA Made
|
JDS6598 Final Drive Gasket - USA Made
|
JDS6601 Final Drive Gasket - USA Made
|
JDS6604 Final Drive Gasket - USA Made
|
JDS6673 Transmission Rear Cover Gasket - USA Made
|
ABC426 Riveted Brake Disc - 10 Spline, 5" Diameter 1-5/8" Spline ID .569 thick --- 4 used per tractor---riveted like the originals were!
|
CKS1601 Disc Brake Linings With Rivets - 6" OD, 3.140" ID., .191" thick
|
MIS1131 Brake Riveting Tool - 1-1/4" throat depth1/8" diameter rivet punch5/16" anvil
|
MIS2547 Deep Throat Brake Rivet Tool - 3-3/8" Deep Throat2-1/8" high throat - USA Made
|
JDS892 Brake Return Spring - 2-3/8" OVERALL LENGTH
|
ABC561 Actuating Spring For Disc Brakes - 0.105 wire diameter 1.275 o/a length; 0.809 o.d.-----4 used per tractor
|
ABC1225 Disc Brake Ball - 7/8" Diameter steel ball (0.875")
|
ABC2831 Oil Seal - John Deere L, LA, LI, M, MC, MI, MT, MTN, MTW, 320, 330, 40, 420, 430, R, 440
|
JDS890 Clutch and Brake Pedal Return Spring - overall length: 5-1/4"wire diameter: 0.093" - USA Made
|
ABC131 Inner Rear Axle Seal or Belt Pulley Seal
|
ABC3639 Tapered Bearing Cone and Cup
|
JDS3013 Engine Clutch Kit - 10" O.D., 10 splines, 1-3/8" spline I.D.
|
JDS3010 New Engine Pressure Plate - 10" O.D., 3 springs
|
JDS3006 New Woven Engine Clutch Disc - 10" O.D. 1-3/8" spline I.D. 10 splines
|
ABC496 Clutch Throw Out Bearing (IH Torque Amplifier Release Bearing) - 2.062" I.D. 0.801" thick 3.269" face diameter (this is where the pressure plate fingers make contact)
|
ABC3149 Clutch Pilot Bearing - ID = 0.669", OD = 1.575", Width = 0.472".
|
ABC412 Clutch Alignment Tool
|
ABC362 Gear Shift Bakelite Knob - 1.250" Diameter 3/8" x 24 NF
|
JDS493 Rubber Gear Shift Boot - 2-1/2" bottom I.D., 9/16" hole I.D., 13/16" - 7/8" hole O.D.
|
ACS254 Gear Shift Lever Washer And Snap Ring Kit - Retains gear shift lever into housing, 0.254" Thick, 1.368" O.D., 0.998" I.D.
|
JDS4789 Gasket, Pinion Shaft Cover
|
|
|