Brake, Clutch, Differential, Rear Axle & Transmission
ACS5884 Transmission Clutch Thrust Washer
|
ACS6900 O.E.M. Shim, Allis Chalmers - USA Made
|
ABC164 Brake Shoe Lining Set - Fits D17 (SN: 42001 & up), D19, D21, 170, 175, 180, 185, 190, Set includes 2 linings with rivets -1 set for 1 wheel only 1.25" W x 7.25" L
|
ABC3703 Brake Band with Riveted Lining
|
ABC5976 Brake Band with Riveted Lining
|
MIS1131 Brake Riveting Tool - 1-1/4" throat depth1/8" diameter rivet punch5/16" anvil
|
MIS2547 Deep Throat Brake Rivet Tool - 3-3/8" Deep Throat2-1/8" high throat - USA Made
|
ACS3731 Brake Return Spring - 0.088" wire diameter, 0.525" to 0.666" O.D., 1.389" overall length
|
ACS3727 Brake Band Return Spring - 0.063" Wire diameter, 0.369 to 0.497" O.D., 1.293" O/A length
|
ACS6020 Brake Pedal Spring - Fits Allis D21, 190, 190XT, 190XT III, 200
|
ABC4219 Brake Band Hardware Kit - 2 kits used per side
|
ABC3477 Actuating Spring (for disc brakes) - 1.294" overall length, 0.110" wire dia., 0.840" O.D. - USA Made
|
ABC2713 1 inch Disc Brake Ball
|
ABC2501 Throw-out Bearing - Sealed bearing, no need to grease. 2.490" I.D., 4.060" O.D., 0.870" wide.
|
ABC496 Clutch Throw Out Bearing (IH Torque Amplifier Release Bearing) - 2.062" I.D. 0.801" thick 3.269" face diameter (this is where the pressure plate fingers make contact)
|
ABC2937 Clutch Pilot Bearing - This is a sealed bearing. 0.984" I.D., 2.047" O.D. and is 0.590" wide.
|
ABC412 Clutch Alignment Tool
|
ABC3113 Clutch Alignment Tool - 10 spline, 1-1/4" spline O.D., 0.970" O.D. pilot, and is 5-1/2" overall length
|
ABC362 Gear Shift Bakelite Knob - 1.250" Diameter 3/8" x 24 NF
|
ACS202 Rubber Knob - 0.400" I.D. hole For ease of installation please lubricate
|
ACS256 Rubber Gear Shift Boot - The hole through the top is 1/2" diameter. The bottom inside diameter of the cover is 2-1/8"
|
ACS255 Standard Gear Shift Lever Pins - 0.314" width for the square end 0.250" shaft diameter
|
ACS045 Transmission Input Shaft
|
ACS046 3rd And 4th Shift Fork
|
|
|