ABC1605 Electric Oil/Fuel Pressure Switch
|
ABC269 Lined Brake Bands - Brake rod unpins from lining, 1 lined brake band per wheel
|
MIS1131 Brake Riveting Tool - 1-1/4" throat depth1/8" diameter rivet punch5/16" anvil
|
MIS2547 Deep Throat Brake Rivet Tool - 3-3/8" Deep Throat2-1/8" high throat - USA Made
|
IHS014 Bake Drum - Does not include set screw or jam nut.
|
ABC1510 Outer Rear Axle Oil Seal - Must reuse your seal retainer 2.125" ID 3.066" OD 0.510" width
|
ABC1503 Oil Seal - 1.625" ID, 2.441" OD, 0.312" wide
|
ABC2819 Differential Bearing Retainer Oil Seal - 1.832" O.D. 1.062" I.D. 0.250" width
|
IHS1516 Final Drive Gasket Set (for 1 side)
|
IHS1518 Final Drive Pan Gasket
|
IHS4817 Clutch Kit - Fits IH 154 & 185 Cub Lo-Boy
|
IHS1234 Cub 154 & 185 Loboy Clutch Pressure Plate
|
IHS1864 New Pressure Plate - 5-1/2" 3 spring
|
IHS2408 Pressure Plate Bolt and Nut - Grade 8, 5/16-18 x 1-5/8" long
|
IHS1861 New Clutch Disc - 5-1/2" O.D., 10 splines, 0.937 spline diameter
|
IHS785 Throw-out Bearing With Release Carrier - uses 10-32 grease zerk INCLUDED) 2.160 OVERALL LENGTH
|
IHS1197 Pilot Bushing - Bronze --- 0.875" OD x 0.750" Long x 0.625" ID
|
IHS730 Clutch Pilot Bushing - Sintered bronze. 0.815" Outside Diameter, 0.625" Inside diameter, 1.000" Length.
|
ABC1437 Clutch Alignment Tool - Plastic, 10 Splines, 15/16" Spline O.D.,0.625 Pilot Diameter
|
IHS2342 Clutch Drive Shaft - 22-5/8 Long
|
IHS2339 Clutch Drive Shaft - 24-1/2 Long
|
IHS2345 Farmall 184 Clutch Drive Shaft - 29-5/8" Long
|
IHS2348 Farmall 184 Clutch Drive Shaft - 23-1/2" Long
|
IHS2351 Clutch Drive Shaft 31" Long
|
IHS1653 Clutch Drive Shaft - 1.060" diameter x 29" long total
|
IHS2325 Creeper Sun Gear Drive Shaft - 6.305" Overall Length, 12 Teeth
|
IHS242 Rubber Knob . 0.285" Hole
|
IHS266 Gear Shift Knob - Can also be used as a reverser knob. 0.375" Hole dia.
|
IHS012 Farmall Cub Newer 2nd and 3rd Sliding Gear - 16 & 26 Teeth
|
IHS013 Farmall Cub 1st and Reverse Sliding Gear - 13 Teeth
|