Carburetor
ABC2426 Choke or Fuel Shut Off Cable Clip - For Marvel Schebler Carburetors
|
ABC223 Carburetor, New Zenith Universal Replacement - 2-5/16" to 2-3/8" CC stud holes (Because of the smaller diameter studs that are included) Throttle Shaft Length = 4.88" Has 1-1/8" throttle bore
|
ABC1346 Zenith Carburetor Repair Kit - This kit contains repair parts for a multitude of Zenith Carburetors - USA Made
|
ABC220 Marvel Schebler Economy Carburetor Repair Kit - This kit contains repair parts that fits a multitude of number of Marvel Schebler carburetors.
|
IHS3613 Premium Carburetor Repair Kit - Fits 130, 140, 330, 304 and 404 with TSX730 and TSX827 Marvel Schebler Carburetors
|
IHS3654 Premium Carburetor Repair Kit - Fits T340, 330, 340 and 404 all with TSX748 (IH # 372985R91) Marvel Schebler carburetor
|
ABC203 Basic Carburetor Repair Kit - Marvel Schebler fitting TSX134, TSX308, TSX309, TSX34, TSX480, TSX520, TSX531, TSX541, TSX665, TSX730, TSX744, TSX748, TSX827, TSX864, TSX896 & TSX896SL
|
ABC3233 Carburetor Gasket Kit - Fits Marvel Schebler Small Bowl Carburetor, The overall length of the bowl gasket is 4-5/16" - USA Made
|
ABC408 Carburetor to Manifold Mounting Gasket - Fits Marvel Schebler TSX241A, TSX241B, TSX241C, TSX33, TSX38, TSX420, TSX428, TSX500, TSX580, TSX83, 2-3/8" - 2-7/16" slotted bolt holes 1-1/8" center hole Approx. 0.062" thick - USA Made
|
ABC190 Zenith Carburetor Float - 2.170" at widest point overall length, 1.826" overall height
|
ABC036 Carburetor Float For small bowl Marvel Schebler carbs. The dimension from center of pin hinge to end of pontoon = 2.375 length
|
ABC230 Marvel Schebler Viton Needle Float Valve - Viton Needle and seat helps stop carb flooding. The orifice measures.080" diameter. 3/8"-27 thread - USA Made
|
ABC513 Throttle Body Repair Bushing - Repairs worn throttle bodies using 1/4" throttle shafts, For small bowl Marvel Schebler carburetors - USA Made
|
REP4082 Marvel Schebler TSX & DLTX Carburetor Service Manual Reprint
|
T819 Throttle Body Repair Bushing - For 1/4" shaft only, Install with sealant
|
ABC297 Carb Elbow Strainer Assembly - Fits various Marvel Schebler Models. Also fits tractors with the Carter UT series carburetors. Must have internal threads, Used with flair fitting not compression fitting Male end
|
IHS1124 Carburetor Elbow With Strainer Assembly - fits the models listed when they are equipped with a 5/16" O.D. fuel line. 1/8" male threads Fits Carter, Marvel Schebler & Zenith carburetors - USA MADE
|
IHS966 Carburetor Elbow With Strainer Assembly - will fit models listed when they are equipped with a 1/4" O.D. fuel line.
|
|
|