ABC016 Ammeter (Amp) Gauge (20-0-20) - Fits 2" diameter hole, Threaded Terminal Type
|
ABC2238 Ammeter Gauge (60-0-60)
|
ABC466 Ammeter (Amp) Gauge 60-0-60 - Fits most tractors equipped with alternator, Fits 2" Diameter hole, Threaded Terminal Type
|
ABC082 Universal Oil Pressure Gauge - Dash mounted gauge, requires a 2" diameter hole, 1/8" NPT Male Threads
|
ABC005 Universal Oil Pressure Gauge - Dash mounted gauge, requires a 2" diameter hole, 1/8" NPT Male Threads
|
ABC538 Oil Gauge Fitting - For gauges without removable fitting
|
IHS626 Oil Gauge Fitting - For gauges without removable fitting 1/8" pipe to 1/4" compression
|
ABC523 Oil Pressure Gauge Copper Line Kit
|
ABC1593 Water Temperature Gauge - Dash mounted, not illuminated, 2" dia., 60" lead, 5/8"-18 U.F. end w/ 1/2" NPT pipe bushing, Probe dia. 0.374", length is 1-3/16"
|
MFS145 Ferguson TO20 & TO30 Tachometer
|
ABC476 Tachometer Drive Assembly - Drives off of the rear of the generator. Includes 14 and 43 tooth gears
|
MFS147 Tachometer Cable - 32-1/4" outer sheath length, Square ends 5/8 - 18 x 7/8 - 18 threads
|
|
|
ABC2285 Electrical Outlet Socket Boot - Fits tractors using single wire outlet
|
FDS271 Wiring Clip - Headlight wiring to dash
|
FDS268 Wiring Clip for 17/32" Hole - Wiring harness to instrument panel brace
|
FDS267 Wiring Clip for 7/16" Hole
|
FDS269 Wiring Clip = 7/16" Bolt Hole, 1/4" Wire Loop Opening
|
FDS270 Wiring Clip - Rear lamp wire to brake actuating shaft
|
ABC395 Electrical Outlet Socket 2 plated brass pins, All implements with lights
|
ABC1868 Auxiliary Male 2-PIn Connector Plug - Plated brass pins, 0.760" wide, 3.045" total length and 0.340" hole diameter for wires
|
MFS2249 Restoration Quality Wiring Harness - for 6 volt generator systems only, includes head light wires & diagram
|
MFS3783 Restoration Quality Wiring Harness - For tractors with 1 wire alternator, includes light wires & diagrams
|
MIS3127 Auxiliary Heater - USA Made
|
MFS140 Starter Switch This switch measures 1" from the top of the mounting plate to the end of the button. The measurement between bolt holes (center to center) is 1-3/4".
| | |