MFS5625 Hydraulic Control Valve
|
MHSK1 Deck Stabilizer Kit
|
MFS5894 Hydraulic Pump Drive Shaft
|
ABC209 Block & Hydraulic Drain Plug - 1/4" - 18 NPT
|
FDS073 Friction Disc - 3" OD, 1/2" CENTER HOLE, 0.210" thick material
|
MFS4670 Hinge Pin (Cat. 1)
|
773126M92 Power Steering Pump - Fits JS Barnes type pump
|
|
MFS3567 Economy Hydraulic Pump Repair Kit - Kit is only correct for #184473M93 pump using a strainer filter and 0.091" diameter pump pistons, flat rings and 10 spline camshaft
|
FDS4671 Draft Control Spring
|
MFS4693 3 point Lift Spring Boot
|
MFS3751 Main Hydraulic Pump Assembly - Using 10 spline, 1-3/8" diameter camshaft and 0.091" pistons and strainer, 2300-2800 PSI, 7-3/4" width 5-1/2" height 12-1/2" overall length
|
MFS4359 Hydraulic Lift Piston Ring Kit - Ford 3" Pistons, includes 3 Rings
|
ABC317 Quadrant Stop Kit - Includes wing nut and flat washer
|
MFS3554 Hydraulic Lift Cover Valve Block Off Plate - 3.775" overall length 2.950" wide (1) 1/8" NPT port
|
MFS3614 Hydraulic Lift Cover Gasket - 0.017" thick
|
MFS3570 Hydraulic Pump Strainer - 4.000" overall length 2.390" O.D. 1.820" I.D., Measure before ordering as there were two (2) different lengths
|
FDS475 Outer Hydraulic Lift Rockshaft Arm - 1.80" I.D. 37 Splines
|
MFS3948 Single Hydraulic Remote Valve With Lever - This valve bolts to the lift cover. Outlets are 1/2" pipe thread
|
MFS3633 Dual Hydraulic Remote Valve Kit
|
MFS3746 Front Hydraulic Pump Adapter Plate (Drive Hub) -with Continental & Perkins gas, LP and diesel engines using 3 bolt front pump drive, adapter plate bolts to the crankshaft pulley
|
ABC435 Drawbar Clevis With Pin - Will not fit 2000 except Rowcrop and 4000 except Rowcrop and Grove
|
ABC2010 Category 1 Adjustable Stabilizer Bar - Adjustable ends for desired length, adjust from 27-1/2" to 37" length. 23" center tube length. 7/8" threaded ends. 7/8" pin holes
|
ABC302 Eyelet Assembly Kit - includes eyelet assembly, nut and lock washer
|
ABC2271 Swinging Drawbar Bolt Kit - Includes 8 bolts and lock washers. 4 bolts 7/16 - 14 x 1 1/2" long and 4 bolts 5/8 - 11 x 1 1/2" long.
|
FDS023 Top Link - Category 1, 16" long tube, 3/4" holes at both ends
|
FDS305 Clevis Pin - Pin ONLY fits the ABC435 style aftermarket brackets
|
FDS022 3 Point Drawbar - Category 1, black primer, measures 1" x 2-1/2" x 26", (approximately 31-1/2" overall length, pin to pin) with a 7/8" pin size
|
FDS028 Leveling Crank Assembly - Closed length 17 1/2", Top Pin To Bottom Pin
|
FDS024 Stabilizer Kit, Category 1
|