IHS5713 Distributor Gasket - USA Made
|
EIGN179 Electronic Ignition II Kit for 4 Cylinder IH distributor with clip mounted cap - USA Made
|
ABC6411 Flame-Thrower II Ignition Coil - USA Made
|
IHS6359 Magneto Point Set
|
IHS5560 Distributor Primary Screw & Insulator Kit, Power Inlet
|
ABC324 Autolite Spark Plug - 18 MM thread diameter 1/2" reach 7/8" Hex Medium hot Power tip/non resistor
|
IHS370 Horizontal Distributor Ignition Tune Up Kit - This will NOT fit any magnetos or Delco or PrestoLite brand distributors. Plug Gap = .025, Point Gap = .020
|
IHS846 IH Ignition Tune Up Kit - For 4 cyl. models using IH HORIZONTAL distributor number 353898R11 or (VERTICAL distributor 460 & 560 Only) number with 367839R92 or 371579R92. It will not fit Delco or Prestolite distributors.
|
EIGN05 Electronic Ignition Kit - 6 Volt Positive Ground System, ONLY fitting an International Distributor - USA MADE
|
EIGN17 Electronic Ignition Conversion Kit - 12 Volt Negative Ground for 4 cylinder IH distributor with clips - USA MADE
|
IHS703 Rotor Button - This rotor button will fit the IH Horizontal Distributor 353898R11
|
|
ABC121 Distributor Cap - Fits 353898R11 IH horizontal distributor, Also fits Cub with J4 magneto
|
IHS763 IH Distributor Dust Cover - this cannot be used on Cub models that have a J4 magneto. Will also fit distributor # 368051R1 & 401107R1.
|
IHS1716 Distributor, Horizontal - CAST STEEL HOUSING LIKE ORIGINAL!
|
IHS2531 Distributor Hold Down Clamp - For IH built distributor with 5/16" hold down bolt. 2 used per engine, sold individually.
|
IHS815 Distributor Drive Shaft - This is NOT the shaft that the points contact or the weights attach to,This IS the shaft that will fall out of the distributor if removed from the tractor
|
IHS6219 6 Volt Electronic Horizontal Distributor, Farmall
|
IHS6209 12 Volt Electronic Ignition Horizontal Distributor - GAS ONLY)
|
IHS739 Distributor Cap Spring Clip - Fits listed IH models when equipped with IH brand distributor 353898R11.
|
IHS3112 Distributor Drive Housing - USE TO CHANGE OVER FROM A MAGNETO, OR TO ADD A TACHOMETER DRIVE TO YOUR TRACTOR. The tachometer drive parts or tach drive blockoff plate are sold separately.
|
IHS3715 Governor and Distributor Drive Bushing - 1.998" I.D. 2.131" O.D. 1.312" Long Note: Mounts in right front side of engine block; may need to be sized after installation.
|
ABC4181 Distributor Drive Housing Bushing - 0.630" I.D., 0.750" O.D., 0.970" long
|
IHS3125 Distributor Tachometer Drive Housing Block Off Plate w/ Gasket - Used to cover tach drive opening when not equipped with tachometer.
|
IHS4457 Distributor Drive Gasket
|
IHS3166 IH Distributor Shaft Bushing and Shim Kit - This is a 5-piece kit. The length is 2.006".
|
IHS766 Distributor Drive Gear
|
IHS974 Insulator - This spring anchor terminal insulator is designed for the IH distributor (353898R11) and for J4 magnetos with a serial number higher than 139748.
|
IHS988 Terminal Screw - This product is a zinc plated Terminal Screw only
|
IHS737 Distributor Cap Spring Clip Bracket Screw With Lock Washer - SCREW SIZE: 8-32 X 3/8" SLT RD, HD MACHINE
|