IHS6219 6 Volt Electronic Horizontal Distributor, Farmall
|
IHS6209 12 Volt Electronic Ignition Horizontal Distributor - GAS ONLY)
|
IHS5560 Distributor Primary Screw & Insulator Kit, Power Inlet
|
IHS3528 International H4 Magneto Point Set
|
|
IHS370 Horizontal Distributor Ignition Tune Up Kit - This will NOT fit any magnetos or Delco or Prestolite brand distributors. Plug Gap = .025, Point Gap = .020
|
IHS846 IH Ignition Tune Up Kit - For 4 cyl. models using IH HORIZONTAL distributor number 353898R11 or (VERTICAL distributor 460 & 560 Only) number with 367839R92 or 371579R92. It will not fit Delco or Prestolite distributors.
|
IHS6356 IH Distributor and J4 Magneto Condenser
|
IHS703 Rotor Button - This rotor button will fit the IH Horizontal Distributor 353898R11
|
ABC121 Distributor Cap - Fits 353898R11 IH horizontal distributor, Also fits Cub with J4 magneto - USA Made
|
IHS763 IH Distributor Dust Cover - this cannot be used on Cub models that have a J4 magneto. Will also fit distributor # 368051R1 & 401107R1.
|
IHS2531 Distributor Hold Down Clamp - For IH built distributor with 5/16" hold down bolt. 2 used per engine, sold individually.
|
IHS3112 Distributor Drive Housing - USE TO CHANGE OVER FROM A MAGNETO, OR TO ADD A TACHOMETER DRIVE TO YOUR TRACTOR. The tachometer drive parts or tach drive block off plate are sold separately.
|
IHS3125 Distributor Tachometer Drive Housing Block Off Plate w/ Gasket - Used to cover tach drive opening when not equipped with tachometer.
|
IHS737 Distributor Cap Spring Clip Bracket Screw With Lock Washer - SCREW SIZE: 8-32 X 3/8" SLT RD, HD MACHINE
|
IHS766 Distributor Drive Gear
|
IHS815 Distributor Drive Shaft - This is NOT the shaft that the points contact or the weights attach to, This IS the shaft that will fall out of the distributor if removed from the tractor
|
IHS974 Insulator - This spring anchor terminal insulator is designed for the IH distributor (353898R11) and for J4 magnetos with a serial number higher than 139748.
|
IHS988 Terminal Screw - This product is a zinc plated Terminal Screw only
|
IHS3715 Governor and Distributor Drive Bushing - 1.998" I.D. 2.131" O.D. 1.312" Long Note: Mounts in right front side of engine block; may need to be sized after installation.
|
IHS3166 IH Distributor Shaft Bushing and Shim Kit - This is a 5-piece kit. The length is 2.006".
|
IHS4457 Distributor Drive Gasket - USA Made
|
ABC6411 Flame-Thrower II Ignition Coil - USA Made
|
IHS1294 Insulating Terminal Washer - This product is a fiber washer measuring: 0.167" Inside Diameter, 0.563" Outside Diameter and 0.135" Thick. Also fits distributor numbers: 353898R1, 368051R1, 401107R1
|
ABC556 Distributor Or Magneto Mounting Gasket
|
IHS5713 Distributor Gasket - USA Made
|
ABC011 6 Volt Distributor Coil - Metal housing, mounting bracket included-- fits tractors with barrel-type coil
|
ABC348 12 Volt Distributor 'HOT' Coil (55000 Volts)
|
ABC509 12V Coil Internal Resisted - Barrel style Internally resisted Includes coil mounting bracket
|
IHS234 6 Volt Distributor Coil - This is an International Harvester OEM style 6 volt distributor coil. This distributor coil has a 1.4 ohm rating between the two primary winding terminals.
|