FDS335 Rear Ball Joint Dust Cover
|
FDS317 Side Mount Distributor - NEW NOT REBUILT ***1/4" HEX DRIVE
|
FDS6582 12-Volt Electronic Ignition Side Mount Distributor Using Hex Drive Shaft
|
FDS476 Ignition Tune-Up Kit - For tractors with SIDE MOUNTED distributor.
|
FDS138 Ignition Tune Up Kit - For tractors with SIDE MOUNTED distributor
|
FDS3253 Distributor Bushing and Shim Kit - This is a 5-piece kit. NOTE: Bushing must be sized to the shaft after installation. - USA Made
|
FDS471 Rotor Button - For tractors with SIDE MOUNTED distributor Use with ABC159 rotor clip.
|
ABC063 Distributor Cap - For use with original style side mounted distributor For tractors with generator/alternator mounted on the LEFT side as sitting in the seat. 3.725 OD
|
ABC6108 Premium Distributor Cap - USA Made
|
FDS3984 Autolite Ignition Point Only - For tractors with side mount distributor.
|
ABC277 Distributor Dust Cover Assembly - For side mounted distributors For tractors with generator/alternator mounted on the LEFT side as sitting in the seat. Includes gasket
|
ABC159 Rotor Clip - For tractors with generator/alternator mounted on the LEFT side as sitting in the seat. This slides on the distributor shaft and keeps the rotor button tight to the shaft.
|
FDS281 Copper Primary Conductor - For tractors with SIDE MOUNT distributors. For tractors with generator/alternator mounted on the LEFT side as sitting in the seat.
|
FDS397 Terminal Junction Block - For tractors with SIDE MOUNTED distributor For tractors with generator/alternator mounted on the LEFT side as sitting in the seat.
|
FDS3823 Distributor Primary Screw and Insulator Kit -
|
FDS224 Distributor Cap Hold Down Clip Clamp, Fits all with side mounted distributor 2 used per engine, sold individually
|
ABC011 6 Volt Distributor Coil - Metal housing, mounting bracket included-- fits tractors with barrel-type coil
|
ABC348 12 Volt Distributor 'HOT' Coil (55000 Volts)
|
ABC509 12V Coil Internal Resisted - Barrel style Internally resisted Includes coil mounting bracket
|
R3528 12 Volt Flame Thrower Coil - for all 12 volt systems requiring horizontal mounting position - Internally Resisted 3 OHMS.
|
ABC4293 6 Volt Flame Thrower Coil - Use with electronic ignition kits or breaker point ignitions Note: Do not use an external resistor on 6 volt electrical systems
|
ABC6158 12 Volt Distributor 'HOT' Coil (55000-Volts)
|
ABC6411 Flame-Thrower II Ignition Coil - USA Made
|
|
ABC366 2 Terminal Style Universal 12-volt Voltage - 2 terminal style Reduces voltage to distributor points 2.0 OHMS of resistance, Limits voltage to coil when using 12-volt battery.
|
ABC322 Autolite Spark Plug - 14 MM thread Dia 7/16" reach 13/16" hex Medium heat range Plug gap 0.025" - Fits Ford 8N with side mounted distributors
|
ACS228 Spark Plug Wire Set - Dimensions= (approximately) 2 wires= 32", 1 wire= 34 1/2", 1 wire = 38", & coil wire = 24" The coil wire is made from excess wire left over from the spark plug wire.
|
FDS149 Spark Plug Wiring Set 4 Cylinder - This spark plug wires set fits most 4 cylinder models. They have copper core wires with aluminum coating to prevent corrosion. And 90 degree boots.
|
FDS331 Tailored Spark Plug Wire Set - PRE-ASSEMBLED - NO CUTTING OR FITTING REQUIRED.
|
ABC4309 Electronic Ignition Spark Plug Wiring Set
|