JDS6033 Spark Plug Wire Holder Bracket - USA MADE
|
ABC018 - Delco Clip Held Ignition Kit - For use on tractors using Delco-Remy distributors with clip held cap through 1963 Delco Distributors Only
|
ABC3978 Ignition Points Only (for Delco Distributor with Clip Held Cap) - For tractors using Delco-Remy distributors only
|
ABC168 Autolite Spark Plug - 14 mm thread diameter 3/8" reach 13/16" hex Medium hot Standard tip/non resistor
|
ABC170 Autolite Spark Plug - 18 mm thread diameter 1/2" reach 7/8" hex Medium hot Std Tip / Resistor Plug gap 0.025"
|
ABC171 Autolite Spark Plug - 18mm thread diameter 1/2" reach 7/8" hex Hot heat range Std Tip / Resistor
|
JDS268 Ignition Tune-Up Kit - For DELCO distributors only Using 18 MM, 1/2" Reach 7/8" Hex Spark Plugs Kit contains: Rotor, Points, Condenser, (2) Spark Plugs Will NOT fit magneto ignitions.
|
EIGN18 Electronic Ignition Conversion Kit - 12 Volt Positive Ground System w Delco Distributor
|
EIGN21 Electronic Ignition Conversion Kit - 12 Volt Negative Ground System w/ Delco Distributor
|
ABC520 Delco Rotor Button - Tractors using Delco-Remy distributors with clip held cap through 1963
|
JDS585 Distributor Cap - Fits John Deere - 520, 530, 620, 630, 720, 730 with Delco Distributor Clip Held Cap For Vertical Distributors
|
ABC186 Distributor Dust Cover With Felt Gasket And Washer - Fits tractors using Delco-Remy distributors with clip held cap thru 1963
|
|
ABC488L Spring Clip And Longer Bracket - Distributor caps use one each of ABC488L & ABC488S FITS DELCO DISTRIBUTORS ONLY, *** WILL NOT FIT IH OR AUTOLITE BUILT DISTRIBUTORS/MAGNETOS **
|
ABC488S Spring Clip And Shorter Bracket - Distributor caps use one each of ABC488L & ABC488S - FITS DELCO DISTRIBUTORS ONLY, *** WILL NOT FIT IH OR AUTOLITE BUILT DISTRIBUTORS/MAGNETOS **
|
ABC2523 Distributor Hold Down Clamp - Used when converting to Magneto to Distributor
|
ABC3007 Delco Distributor Shaft Bushing and Shim Kit - has an 0.486" I.D., 0.656" O.D. and 2.867" length. Bushing must be sized to shaft after installation
|
ABC500 Delco Distributor Terminal Insulator - Square was the late style that fit distributor housings with .300 Dia hole with a keyway, WILL NOT FIT IH BUILT DISTRIBUTORS/MAGNETOS
|
|
ABC348 Vertical Hot Coil 12 Volt Externally Resisted 55000 - Delco distributors WITH SCREW HELD CAP --- Kit contains: Heavy duty point set vibration resistant condenser and rotor
|
ABC509 12V Coil Internal Resisted - Barrel style Internally resisted Includes coil mounting bracket
|
R3528 12 Volt Flame Thrower Coil - for all 12 volt systems requiring horizontal mounting position - Internally Resisted 3 OHMS.
|
ABC366 2 Terminal Style Universal 12-volt Voltage - 2 terminal style Reduces voltage to distributor points 2.0 OHMS of resistance, Limits voltage to coil when using 12-volt battery.
|
JDS643 Spark Plug Wiring Set With Copper Wire - These wires are approx. 32 & 49" long, have a copper core with aluminum coating to prevent corrosion and a Neoprene Outer Cover.
|
JDS4335 Spark Plug Wiring Set with 90 degree Boots, 2-cyl. - Used with Electronic Ignition Kits - EIGN07, EIGN18, EIGN20, EIGN21
|
JDS085 Coil - For 6 Volt Systems
|
JDS103 Wico Pony Distributor - For 6 Volt Systems ONLY........Complete with coils, points and wires. It also includes the AF2143R (JDS3216)resistor for the combo switch.
|
JDS125 Pony Distributor Wico Points - Fits JDS103 Pony DISTRIBUTOR "WICO
|
JDS126 Condenser - For 6 Volt Systems ONLY........JDS103 Pony DISTRIBUTOR "WICO, .................2 REQUIRED PER TRACTOR; SOLD INDIVIDUALLY
|
JDS232 Spark Plug Wire Set - JDS103 Pony DISTRIBUTOR "WICO, Sold as set only. Cut spade off & slide in coils
|