ABC065 Ignition Switch, Key Switch
|
ABC6693 Prestolite/Autolite Distributor Cap - USA Made
|
ABC547 Starter Drive Bendix - 10 teeth turns clockwise to engage ring gear
|
IHS132 Starter Drive BENDIX - 10 tooth, Improved positive ratchet style drive
|
ABC458 Starter Drive Assembly - 10 Teeth
|
ABC1179 12 Volt Starter Solenoid For Delco Starters
|
1114458 12 Volt Starter Solenoid For Delco Starters - Premium USA Made
|
ABC1366 Delco Starter Solenoid - 12 Volt
|
24021BX Solenoid 12 Volt - 4 Terminal Flat Mount, Gas models only
|
15-407 Solenoid 12 Volt - 4 Terminal Flat Mount, Intermittent Duty
|
MIS065 Battery Disconnect Switch - Can also be used to stop battery drain on a tractor in storage. USA MADE
|
ACS275 Starter Switch Lever - For "PUSH" rod type starter switch system - USA Made
|
ABC138 Solenoid Starter Or Manifold Heater Switch - 12 Volt System Only
|
ABC018 Premium Delco Ignition Tune-Up Kit with Rotor - For use on tractors using Delco-Remy distributors with clip held cap through 1963 Delco Distributors Only
|
ABC333 Ignition Tune-Up Kit - Delco distributors WITH SCREW HELD CAP --- Kit contains: Heavy duty point set vibration resistant condenser and rotor
|
ABC555 Ignition Tune-Up Kit - Fits Delco Distributor w/ clip held cap Works ONLY on listed 6 cylinder models, Spark Plug thread size is 18 MM diameter 1/2" Reach and 7/8" Hex Replaces Champion D16 & D21 Spark Plug GAP = .025, Point Gap = .020
|
MFS096 Ignition Tune-Up Kit - Fits Delco Distributor w/ clip held cap 4 cylinder models ONLY Contains spark plugs, heavy duty points, condenser, and rotor button Spark plug thread size is 18 MM diameter 1/2" Reach and 7/8" Hex
|
ABC6204 Delco Point Set - USA Made
|
ABC520 Delco Rotor Button - Tractors using Delco-Remy distributors with clip held cap through 1963
|
ABC330 Distributor Cap This fits 6 cylinder models using a Early Delco Remy Distributor with a clip held cap #824735 - USA MADE
|
ABC141 Distributor Cap - For 4 Cyl. Delco Distributor with screw help cap (1963 & up)
|
ABC276 Distributor Cap - Fit tractors using Delco-Remy distributors with clip held cap through 1963.
|
ABC6165 Premium Delco Distributor Cap - USA Made
|
ABC186 Distributor Dust Cover With Felt Gasket And Washer - Fits tractors using Delco-Remy distributors with clip held cap thru 1963
|
ABC2428 Delco Distributor Dust Cover Screw Held - 3.300" OD, 1.047" tall, (2) 0.210" screw holes Fits IH Delco distributor numbers: 1112477, 1112489, 1112697.
|
ABC4235 Distributor Dust Cover with Felt Seal - fits Autolite distributors only with 3-3/8" O.D. caps
|
ABC3007 Delco Distributor Shaft Bushing and Shim Kit - has an 0.486" I.D., 0.656" O.D. and 2.867" length. Bushing must be sized to shaft after installation
|
ABC488L Spring Clip And Longer Bracket - Distributor caps use one each of ABC488L & ABC488S FITS DELCO DISTRIBUTORS ONLY, *** WILL NOT FIT IH OR AUTOLITE BUILT DISTRIBUTORS/MAGNETOS **
|
ABC488S Spring Clip And Shorter Bracket - Distributor caps use one each of ABC488L & ABC488S - FITS DELCO DISTRIBUTORS ONLY, *** WILL NOT FIT IH OR AUTOLITE BUILT DISTRIBUTORS/MAGNETOS **
|
ABC498 Delco Distributor Terminal Insulator Assembly - Fits distributor housings with 0.345" diameter round hole, Will not fit IH built distributors / magnetos
|