IHS6209 12 Volt Electronic Ignition Horizontal Distributor
 IHS6209 12 Volt Electronic Ignition Horizontal Distributor IHS6209 12 Volt Electronic Ignition Horizontal Distributor IHS6209 12 Volt Electronic Ignition Horizontal Distributor IHS6209 12 Volt Electronic Ignition Horizontal Distributor IHS6209 Diagram |
|
Item Number: IHS6209
|
IHS6209 12 Volt Electronic Ignition Horizontal Distributor International / Farmall Tractors Fits: (w/ IH horizontal distributor # 353898R1): A, I4, AV, Super A, Super AV, Super AV-1, B, BN, C, Super C, Cub, Cub Loboy, H, HV, Super H, Super HV, M Super M, MTA, Super MTA, MV, Super MV, Super MVTA, O4, OS4, O6, OS6, W4, Super W4, W6, Super W6, W6TA, Super W6TA, 100, 130, 140, 200, 230, 240, 300, 330, 340, 404, 424, 444, 450, W450, 504 (All Gas; Replaces: 107296C91, 107299C91, 107302C91, 107304C91, 353890R91, 353898R11,353898R11 (International-Distributor Housing Casting Number),354900R91,357935R91,362473R91,362722R91,364653R91,364696R92,366928R91,372712R91 Never change points or Condenser Again For 12 Volt Negative Ground System. Purchase if you have a 6 Volt System IHS6219 Farmall 6 Volt Electronic Horizontal Distributor |
IHS1716 Distributor, Horizontal - CAST STEEL HOUSING LIKE ORIGINAL!
|
IHS2531 Distributor Hold Down Clamp - For IH built distributor with 5/16" hold down bolt. 2 used per engine, sold individually.
|
IHS3112 Distributor Drive Housing - USE TO CHANGE OVER FROM A MAGNETO, OR TO ADD A TACHOMETER DRIVE TO YOUR TRACTOR. The tachometer drive parts or tach drive block off plate are sold separately.
|
IHS3125 Distributor Tachometer Drive Housing Block Off Plate w/ Gasket - Used to cover tach drive opening when not equipped with tachometer.
|
IHS815 Distributor Drive Shaft - This is NOT the shaft that the points contact or the weights attach to, This IS the shaft that will fall out of the distributor if removed from the tractor
|
IHS237 12 Volt Distributor Coil - This is an International Harvester OEM style 12 volt distributor coil. This distributor coil has a 2.8 ohm rating between the two primary winding terminals.
|
|
|